Browse Categories

1994-2003 Dieselsite 7.3L Head Studs


Dieselsite 7.3L Head Studs, Powerstroke
Part Number:
DSI:73STUD
Dimensions:
0 x 0
Your Cost:
$399.00
IN STOCK AND READY TO SHIP!

Product Description

Use Dieselsite 7.3L Head Studs on the following vehicles:
1994-2003 Ford F-Series Trucks with 7.3 Liter Powerstroke Diesel Engine
Ford E-Series Vans with 7.3 Liter Powerstroke Diesel Engine
Ford Excursion w/ 7.3 Liter Powerstroke Diesel Engine

Includes the following Dieselsite Pieces:
28 Long Head Studs
8 Short Head Studs
36 12-point nuts
36 Hardened Washers
1 Container of Fastener Assembly Lubricant


  • INSTALLATION FOR HEAD STUD KITS

    1. Inspect all hardware prior to installation. Look for defects or shipping damages, plus proper fit, length and dimension.
  • 2. To ensure proper thread engagement and accurate torque readings, clean ALL threads in the block. Chase if necessary with a Thread Chaser.
  • 3. Screw head studs into the block “HAND TIGHT ONLY” Use Allen key drive only to get stud past small restriction in the threads.
  • RELOAD (TORQUE) RECOMMENDATIONS

    Rated at 220,000 psi tensile strength

  • Following the manufacturers recommended torque sequence tighten the nuts in three equal steps to the following using Dieselsite Fastener Assembly Lubricant on studs, washers and nuts.


  • Our 2 Sequence Torque Specification Guide:

  •   Step 1- Torque to 45 Ft/Lbs using Sequence 1 below

  •   Step 2- Torque to 85 Ft/Lbs using Sequence 1 below

  •   Step 3- Torque to 140 Ft/Lbs using Sequence 2 below

  •   Step 4- Torque to 220 Ft/Lbs using Sequence 2 below